The steam generator design procedure outlined in Section 5 is based on the effectiveness. In this…

The steam generator design procedure outlined in Section 5
is based on the effectiveness. In this problem we want to design the steam
generator by using a differential approach. [Hint: Writing a steady state
energy balance in the axial and transverse directions for an element of length
alongside the tubes gives:

where subscripts i, s, and o stand for tube side, tube, and
tube-bundle-side. Use Equation IVa.6.8-2 to relate the various thermal
resistances, as shown below, to the overall heat transfer coefficient.

View complete question »

The steam generator design procedure outlined in Section 5
is based on the effectiveness. In this problem we want to design the steam
generator by using a differential approach. [Hint: Writing a steady state
energy balance in the axial and transverse directions for an element of length
alongside the tubes gives:

where subscripts i, s, and o stand for tube side, tube, and
tube-bundle-side. Use Equation IVa.6.8-2 to relate the various thermal
resistances, as shown below, to the overall heat transfer coefficient.

Substitute for Ti – To from Equation 2
and integrate from inlet (I) to exit (E) to obtain:

To find the required tube surface area, you need to find the
heat fluxes at the inlet and exit of the tubes. These are determined from
Equation 2 by using the Newton Raphson method].

View less »